Tie Down Jet Rail - Manual (Page 6)

6
9. Assemble Bow Stop
Attach 4 inch spool rollers to the bow stop using two hex
head bolts, 5" x 1/2", two flat steel washers and two 1/2"
nyloc nuts. The washers are used on top of the rollers.
(Picture 12)
Slide the bow stop over the upright winch mount tube, rub-
ber rollers in the "up" position. Using the holes in the bow
stop plate next to the winch mount tube,place a 4 inch x
3/8" bolt and nyloc nut. Tighten bolt so that the bow stop is
about 12 inches below the top of the tube. You will adjust
this later to fit your watercraft.
10. Attach Winch & Winch Mount to
Winch Mount Tube
Attach winch mount to winch using three - 3/8" x 1" hex bolts
and nyloc nuts (picture 13). Attach winch mount & winch, to
tube as shown in picture 14, using two - 3/8" x 4" hex head bolts.
(Picture 14)
Parts required for this step.
# Stk. # Description Qty.
8 26612 Bow Stop 1
23 17052 Spool Rollers, 4" 2
30 10938 1/2" x 5-1/2" 2
Hex Head Bolt
33 10645 1/2" Nyloc Nut 2
37 BBW500 1/2" Flat Washers 2
28 BBB3750400 3/8" x 4" Hex Head Bolt 1
34 BBN375NL 3/8" Nyloc Nut 1
Parts required for this step
13 17150 Winch 1
28 BBB3750400 3/8" x 4" Hex Head Bolt 2
34 BBN375NL 3/8" Nyloc Nut 2
7 26611 Winch Mount 1
27 BBB3750100 3/8" x 1" Hex Head Bolt 3
34 BBN375NL 3/8" Nyloc Nut 3
30 & 37
33
23
13
Picture 13
27 & 34
7
Picture 12
Picture 14
9
8
Requires part #'s ` 10985 qty. 1
10645 qty 2
44540 qty 1
See "NOTE" on Page 8
for this step.