Tie Down Turbo Lube Replacement O-Ring - Manual

110608,C611
O-Ring
Old o-ring
Old o-ring
O-Ring
Turbo Lube Replacement O-Ring Instructions
1. Unscrew cap several turns to allow space
between cap and hub so that the o-ring can be
removed without any oil coming out of the hub.
Use a pick or needle nose plier to remove the
old o-ring.
2. Cover the O-ring with a light coat of oil.
3. Stretch the new O-ring over the cap and
in-between the cap and hub.
4. Hand tighten cap until snug. Use wrench to turn
an addition 1/4 turn. Check to make sure the
O-ring is seated properly. Be careful not to over
tighten. Check oil level, fill if necessary. Tighten
oil plug cap.
1
3
4
TIE DOWN ENGINEERING • 255 Villanova Drive SW • Atlanta, GA 30336
www.tiedown.com (404) 344-0000 Fax (404) 349-0401