TeeJet LH INTELLITRAM 500 - Manual (Page 13)

LH ”I NTELLITRAM ” 500 O PERATORS MANUAL
LH A GRO 13
ENCODE
The encodement menu is selected from the main menu (press the menu key). Use
hereafter the ARROW UP and ARROW DOWN keys to mark “Encode”. Press
thereafter the ENTER key. The same principle is used to select the individual
encodement menus.
The machine type and the implement sensor delay must be encoded first.
These encodements are found in the system menu (see page 22).
Encode the machine settings next as these are machine related and need
only be encoded once.
KG LEFT
To see how much seed is left in the hopper, the amount filled must be encoded
here. This value can be reset by pressing the “C” key.
If there is seed remaining in the hopper when filling then this amount must be
added to the amount filled as follows:
Amount remaining + new amount filled = kg left (total amount in hopper)
TRAMLINING RHYTHM
For more information on the different tramlining rhythms see page 24.
SHOW PRESENT RHYTHM
Information on the currently selected rhythm can be seen here.
CALCULATE NEW RHYTME
The procedure for calculating a new rhythm is as follows:
1. Move the cursor to “Calculate new rhythm” and press the ENTER key.
2. Encode the working width of the implement used to cultivate the crop and
press the ENTER key.
3. Define where the clutches (traditional machines) or shutters (pneumatic
machines) are fitted and press the ENTER key.
4. Move the cursor to “Calculate new rhythm” – press the ENTER key and a
new rhythm is automatically calculated.
5. Check the values shown. Attention should be paid to whether the field
should be started on the left or on the right side (see page 24 for more
information).