TeeJet LH 1200 - Manual (Page 21)

LH 1200 O PERATORS & F ITTING MANUAL F ITTING T HE LH 1200
LH A GRO 21
FITTING THE LH 1200
FITTING THE MONITOR
Fit the monitor where it can be easily seen by the operator whilst driving. We
recommend on top of the instrument panel or to the right-hand side of the cabin
above the lift operating handles.
The form supplied with the LH 1200 can be stuck in the cabin so that the noted
values can easily be found and re-entered if necessary.
POWER SUPPLY
The supplied power cable should be connected to 12V so that the monitor is
switched on and off with the ignition (ignition live).
The power cable wires should be connected thus:
Blue = +12V (power)
Brown = 0V (ground)
IMPORTANT! Never incorrectly connect these wires, as the monitor will be
damaged instantly.
GENERAL WIRING
Lead all cables so that they are as protected as possible. Wherever possible lead
the cables alongside existing cables, hydraulic pipes or similar, and fasten with the
supplied cable ties.
Beware of moving parts and heat sources, e.g. exhaust pipes.
Cables in the cab that cannot be hidden should be fastened with adhesive cable
fasteners, clean the surface thoroughly with, i.e. alcohol before sticking the cable
fasteners to the surface.