TeeJet 834-P Sprayer Control - Manual (Page 13)

TECHNOLOGIES 834-P Sprayer Control
13 98-70028-R0
Console Programming (GPA Mode)
To begin the programming process:
Be sure the Master boom switch is “OFF.”
Turn console “ON” by pressing the key. When the control console is turned on, the
software version will be displayed for approximately 5 seconds. At the same time all
LED’s will be ON.
The software version and serial number of the console will be needed when calling for
support. The serial number is located on a sticker on the back of the console.
Example: the software version is Y1.04.
After a short time the console will change to the target application rate display.
tip
select
GPA
GPT
SPEED
RPM PSI
On
Inch
lbs/rot
PROGRAM MODE push 3 sec.
Y1.04
Gal/min
@40 psi
P/300ft
P/rot
MPH
RPM
min
tip
select
GPA
GPT
SPEED
RPM PSI
On
Inch
lbs/rot
PROGRAM MODE push 3 sec.
t20.0
Gal/min
@40 psi
P/300ft
P/rot
MPH
RPM
min