TechniSat TechniVision ISIO 55 - Manual (Page 22)

6 Operating the unit
6.1 Switching the TV on and off
6.1.1 Switching on using the mains power switch on the television
> Switch on the television by pressing in the mains power switch.
The TV now performs an initialisation and cannot be operated during this time. This
process takes several seconds to complete.
6.1.2 Switching on from standby mode
> Switch the TV on by pressing the On/Stand-by button on the remote control or on
the TV, or the Channel +/- keys on the remote control or on the TV, or a numeric key
between 0 and 9 on the remote control.
If the user-dependent parental control (TechniFamily) is activated under section 10.8 of
the instruction manual, the user selection now appears according to section 7.1.3 of the
instruction manual.
6.1.3 Switching off to standby mode
> Switch the TV off by pressing the On/Stand-by button.
When switching off the TV, please note that it checks whether a new operating software
version or channel list is available. This process takes several seconds to complete.
The LCD panel is already switched off during the test.
The device switches completely into standby mode after completion of the test. The
TV is now in standby mode and can be completely switched off using the mains power
switch.
6.1.4 Switching off using the mains power switch on the television
> The television is switched off completely by pressing the mains power switch.
The device notes the last switching status (“On” or “Off”) entered using the remote
control or the television buttons.
If a power failure occurs during operation, you should switch off the television using the
mains power switch so that it is not switched on again unintentionally as soon as the
power is available again.
You should only switch the television off from standby mode using the mains power
switch, to prevent damage to the database.
22