TechniSat TechniVision ISIO 55 - Manual (Page 10)

4.3 Accepting settings / Exiting menus and functions
In some menus and functions the changes made must be accepted manually in order to save
them permanently. If this does not happen, the function or the values that existed before the
change was made will be reset automatically on exiting the menu.
If an Accept field or the green function key with Accept is displayed in the bottom
line of the screen, you can see that the changes made must be saved manually to be
accepted.
> By highlighting Accept using the right/left arrow keys and confirming with the
OK button or by pressing on the green function key (Accept), the changes are
saved and you return to the next menu level up.
Alternatively:
>
Press the Return button.
A request appears asking whether the changes you made should be applied.
> Use the right/left arrow keys to highlight Yes or No and confirm your selection by
pressing the OK button.
Changes will now be saved or discarded according to your selection and you move
back to the next menu level up.
Alternatively:
>
Press the Menu button to directly leave the menu.
The settings which need to be saved manually will be reset in this case.
If the green function key with Accept is not displayed in the bottom line of the
screen, the changes are saved automatically on exiting the menu.
4.4 Changing a setting
You can create settings using the arrow selection method, the selection list, by
entering numbers and by using the virtual keyboard. The television specifies the
method that can be used to change a highlighted setting. You can see this from the following
displayed symbols:
-
Arrow selection method (section 4.4.1)
Arrows are shown on the left or right edge of the highlight.
- Selection list (section 4.4.2)
The symbol is shown on the right edge of the highlight.
- Entering numbers (section 4.4.3)
- Virtual keyboard (section 4.4.4)
The symbol is shown on the right edge of the highlight.
10