SUUNTO AMBIT2 R User Guide - Manual (Page 125)

1. 2-3.
CALIBRA...
[...............]
[...............]
Hold to
enter
option
Suunto Ambit2 starts calibrating the POD and indicates if the
calibration succeeded or failed. The bottom row of the display
shows the current frequency used with the power POD. The
previous frequency is shown in parentheses.
Calibration
ongoing...
Calibration
successful
120(150)
If your power POD has an auto zero feature, you can turn this
on/off through your Suunto Ambit2 .
To set auto zero on/off:
1. After the calibration is completed, press [Start Stop].
2. Set auto zero On/Off with [Light Lock] and accept with [Next].
3. Wait until the setting is completed.
4. Repeat procedure if setting fails or power POD is lost.
125