Sonics 2055-Press - Manual (Page 10)

CONNECTIONS
When making the initial connections, make sure all electrical power is
disconnected.
1. Connect the air supply source to the press air connection located at the
rear of the press head, using a hose having a minimum inside diameter of
1/8 inch (3 mm).
A 1/4 NPT threaded female elbow connector is provided to attach your air
line service. Connectors are typically an instant (push-to-connect) plastic
tube fitting or a male sleeve lock type quick connect fitting.
2. Connect the RF and base (actuating) cables of the press to the power
supply. (Consult your power supply instruction manual for details.)
3. Check with your electrician if you have any wiring questions.
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L 2 0 5 0 / 2 0 5 5
9
NOTE: Do not strain or
kink the cables. When
going around corners,
allow as wide a bend as
possible. Do not run the
cables parallel to any
power line within a distance
of less than 1 foot
(304.8mm).
AIR
CONNECTOR
(IN REAR)
MODEL 2055
MODEL 2050
CONNECTOR
Go To Top Of Document