Slant/Fin SC-9 - Manual (Page 15)

THE CONTROL MUST BE ADJUSTED FOR YOUR APPLICATION.
IF ANY OF THE DEFAULT SETTINGS DO NOT SUIT YOUR APPLICATION, GO TO THE ADJUSTING SECTION
THAT FOLLOWS EACH FUNCTION AND WRITE IN THE DESIRED SETTING IN THE SQUARE BOX
PROVIDED FOR THAT FUNCTION. THEN PERFORM THE ADJUSTMENT AS LISTED.
THESE INSTRUCTIONS ARE WRITTEN WHERE EACH FUNCTION IS ADJUSTED IN A “ STAND ALONE ” MANNER MEANING YOU ARE PROGRAMMING
THAT ONE FUNCTION ONLY . IF YOU WANT TO PROGRESSIVELY GO THROUGH EACH STEP , JUST SKIP THE INSTRUCTIONS WRITTEN IN
ITALIC LETTERS FOR EACH STEP AND PROGRAM THE CONTROL PROGRESSIVELY THROUGH EACH FUNCTION .
IT IS BEST IF YOU TAKE A FEW MINUTES TO GO THROUGH THE ENTIRE LIST OF FUNCTIONS AND
ENTER ANY NEW SETTINGS THAT ARE APPROPRIATE FOR YOUR INSTALLATION . WHEN FINISHED ,
GO TO THE CONTROL AND ADJUST ONLY THOSE FUNCTIONS THAT HAVE A NEW SETTING LISTED .
P
ROGRAMMING
F
OR
M
OST
A
PPLICATIONS
Programming sequence for most applications is covered in this section. This is followed when the Advanced/Installer
DIP switch is set to Installer.
Set Adv/Installer DIP switch to Installer
SC-9 Controller 15
Display Description
Default
Setting
New
Setting
Room Occupied - The desired room air temperature during the occupied period.
Press the Menu button until ADJUST is visible on the top line of the display. Press the
Item button until ROOM appears above the temperature readout and OCC is flashing
below it. Use the up and down arrow buttons to change to the desired reading.
This item is only available if the External Input/Stand Alone DIP switch is set to
Stand Alone.
Range Available: 35˚ to 100˚F (2˚ to 38˚C)
70˚F
(21˚C)
Room Unoccupied - The desired room air temperature during the unoccupied period.
Press the Menu button until ADJUST is visible on the top line of the display. Press the
Item button until ROOM appears above the temperature readout and UNOCC is flashing
below it. Use the up and down arrow buttons to change to the desired reading.
This item is only available if the External Input/Stand Alone DIP switch is set to
Stand Alone.
Range Available: 35˚ to 100˚F (2˚ to 38˚C)
65˚F
(18.5˚C)
Boiler 1 - Selects whether or not module 1 is operational - Au (auto) or OFF
DO NOT CHANGE
Press the Menu button until ADJUST is visible on the top line of the display. Press
Item button until BOIL to the left of, and above Au and 1 is below it. Use the up and down
arrow buttons to change setting. However for the setting of Au should be retained, do not
change to OFF. Au
SPACE HEATING ONLY WITH OUTDOOR RESET
See Page 17 for instructions to program control using ˚C