2 grip panel installation – SIG SAUER P290 User Manual
Page 53
www.sigsauer.com
53
when it counts
™
8.7.3 grip Panel Removal and installation
8.7.3.1 grip Panel Removal
1. remove the rear housing pin.
2. Slide the grip panel towards the bottom of the magazine well and remove.
8.7.3.2 grip Panel installation
1. align the grip panel with the corresponding dovetails on the frame.
2. Slide the grip panel towards the slide until fully seated. Verify the holes
for the rear housing pin are aligned.
3. install the rear housing pin.
See also other documents in the category SIG SAUER Sports and recreation:
- AIRSOFT PISTOL (Handling & Safety) (20 pages)
- P239 (88 pages)
- P238 (68 pages)
- P226 X-Five (21 pages)
- P250 (68 pages)
- P320 (68 pages)
- P556 (60 pages)
- SP2022/SP2022М (64 pages)
- SP2340 (24 pages)
- MOSQUITO (28 pages)
- P232 (48 pages)
- 1911 (15 pages)
- 1911 Ultra Addendum (2 pages)
- 1911 .22LR (64 pages)
- P522 Pistol (31 pages)
- P210 (20 pages)
- BLASER R93 (24 pages)
- BLASER K95 (24 pages)
- BLASER Tac2 (36 pages)
- SSG 3000 (72 pages)
- SIG516 Rifle (96 pages)
- SIG716 Rifle (96 pages)
- SIG522 Rifle (31 pages)
- SIG 551-A1 Rifle (100 pages)
- SIG556 (104 pages)
- SIG556xi (84 pages)
- SIG556 Grip-Light Operating (4 pages)
- SIGM400 Rifle (84 pages)
- SIG50 (60 pages)
- SHR 970 (20 pages)
- SWISS ARMS SG552 (33 pages)
- MAGPUL CTR Stock (1 page)
- SIG522 and SIG556 Charging handle (2 pages)
- SIG522 Sight Kit Installation (2 pages)
- SIG522 Barrel Removal and Replacement (1 page)
- SIG522 Recoil Spring Upgrade (2 pages)