SeaLand 4400 Series Toilet Installation - Manual (Page 8)

8
Installation Dometic 4300/4400 Series Toilets
Caution
If replacing an existing toilet that uses a 2-bolt floor flange, drill two 5/16-inch dia . holes in
old floor flange that align with two additional holes in floor flange adapter . Use two #10 or
12 x 1-1/2-inch wood screws and washers for these drilled holes, and two T-bolts with flat
washers and nuts to fasten flange gasket and floor flange adapter to old floor flange .
Do not use old hardware or seal .
13 . REMOVE RED CAP FROM FLANGE ADAPTER, lubricate O-ring with silicone grease, and
temporarily set the toilet in place on the floor flange (fig . 14 ) .
14 . Mark the holes for the two toilet mounting bolts (fig . 15 ) .
15 . Pick up toilet and set aside . Drill 3/16-inch pilot holes in the floor (fig . 16 ) .
16 . With toilet close to floor flange, connect flexible water supply hose to water line fitting (fig . 17 ) .
17 . Connect the positive (+) 12 VDC wire to the red power wire that’s connected to the toilet base .
Connect the negative (-) 12 VDC wire to the black wire (fig . 18 ) .
14 15 16
18 17
Note: If installing model 4410 toilet with remote switch
Install wall switch according to instructions on page 10 . Route wall switch wires up through
water line hole .
Caution
DO NOT ATTEMPT TO SLIDE THE TOILET OVER THE FLANGE ADAPTER . THE TOILET
MUST BE SET DOWN OVER THE ADAPTER TO PREVENT POSSIBLE DAMAGE .