SeaLand 4400 Series Toilet Installation - Manual (Page 4)

4
General safety instructions Dometic 4300/4400 Series Toilets
Caution! Hazard of Flooding
If the toilet uses fresh water for flushing and is connected directly or indirectly to a
municipal water system at ANY time, water connections MUST be disconnected if the
vehicle is unattended (even if vehicle is unattended for a brief period) . Failure to do so can
result in flooding which can cause loss of property and life .
Caution!
Overfilling the holding tank can create serious damage to the sanitation system, such as
rupturing the holding tank and releasing tank contents . To prevent this possibility, Dometic
recommends using the “full” tank shut-down relay in the toilet’s electronic control module .
The “full” signal from the holding tank can be generated by an optional Dometic DTM01C
tank monitor or DTM04 four-level tank monitor system .
2.3 Warnings – all applications
Caution! Hazard of Flooding
If toilet uses raw water for flushing at ANY time, a raw water pump controlled by an auto-
matically operating demand switch MUST NOT be installed . If the onboard water valve or
any plumbing connections were to leak, the automatically operated pump would start and
could flood the boat . Failure to comply can cause loss of property and life .
Caution! Hazard of Shock or Fire
Always use recommended fuse, circuit breaker and wire size . Failure to do so can result in
fire that can cause the loss of property and life .
Caution! Hazard of Flooding
If toilet rim is below the waterline at ANY time (during any conditions of heel, load or trim)
and is connected to ANY through-the-hull fittings, properly positioned ventilated (vented)
loops MUST be installed in intake* or discharge piping to prevent potential back siphonage
of seawater into the boat . Failure to do so can result in flooding which can cause loss of
property and life .
* if connected to raw water
3 Components
(fig . 1
, page 2)
Ref. Description
1 Vacuum breaker
2 Bowl water supply hose
3 Water valve
4 Plug-in discharge fitting
5 O-ring
6 Water line/connector
7 Flush ball motor/drive linkage
Ref. Description
8 Manual flush lever
9 Manual flush lever access cover
10 Flush handle (4400 series)
11 Flush handle cable connector
(4400 series)
12 Flush switch (4300 series)
Refer to complete parts list (packed separately)
for additional information .