SeaLand DVS02 Vacuum Status Control - Manual (Page 7)

7
5.3 Dimensions (fig. 2 , page 2)
Ref. Dimension
A 83 mm / 3 .25 in .
B 83 mm / 3 .25 in .
C 51 mm / 2 in . clearance behind wall
D 10 mm / 0.38 in.
5.4 Approvals
ISO 8846; EMC Directive 2004/108/EC; CE approved for electromagnetic compatibility
6 Installation
6.1 Vacuum status control panel (fig. 1 A, page 2)
Caution!
Do not install DVS02 panel in area with potentially flammable or explosive vapors.
1 . Select panel location away from direct contact with water
and oil .
2 . Confirm clearance for wire connections behind wall, hull
liner or bulkhead .
3. Using control panel template (fig. 4 , p . 3), cut out panel
access hole (E, F) and drill fastener holes (G).
4. With electrical power off, route 14-gauge stranded copper
wire (or other wire according to ABYC standards) from
power source to panel location . Route additional wire
according to appropriate wiring diagram (fig.
5 - 7
,
pp . 8 - 9 – wiring diagram schematics), depending on your
application, to panel location . Make sure wires extend out
through access hole .
5 . Make proper wiring connections to wires extending from
bottom of circuit housing (fig. 1 4, p . 2) .
6. Remove panel cover (fig. 1 1, p . 2) from circuit panel/
mounting frame assembly (2, 4), if necessary, by carefully
pulling them apart .
7. Install mounting frame to wall with four fasteners (fig. 1 3,
p .2) .
8 . Push panel cover onto mounting frame until it locks .
9. Turn on electrical power to DVS02 panel. Turn on DVS02 power switch (fig.
3 B, p . 2) and
confirm normal operation of status lights .
DVS02 Panel Template
Dimensions
(fig. 4 , page 3)
Ref. Dimension
A 83 mm / 3 .25 in .
B 83 mm / 3 .25 in .
C 67 mm / 2 .63 in .
D 67 mm / 2 .63 in .
E 55 mm / 2 .16 in .
F 68 mm / 2 .69 in .
G 2 mm / 0.10 in. dia.
H Cut-out area .
Allow 51 mm / 2 in .
clearance behind
wall .
Dometic Vacuum Status Control Panel Specifications