SeaLand VacuStat Status Panel with Vimar and Gewiss Control Panels User Manual
Vacustat, Status panel with vimar and gewiss control panels, Installation instructions

Part Number
Description
313710012
VacuStat - Vimar 12 VDC
313710024
VacuStat - Vimar 24 VDC
313711012
VacuStat - Gewiss 12 VDC
313711024
VacuStat - Gewiss 24 VDC
Specifications
Average Current Consumption for 12 or 24 VDC Models:
0.016 Amps
Features
•
A desirable accessory for VacuFlush
®
systems.
•
Continuously monitors status of vacuum for proper operation.
•
Green light indicates that it is ready to flush.
•
Red light indicates that the vacuum pump is running or, if connected to a TankWatch
®
4 level indicator
with shutdown relay, denotes that the holding tank is full.
Installation Instructions
1. Choose an appropriate location for the VacuStat panel.
2. Install the Vimar or Gewiss backing plate (not supplied).
3. Route wiring according to appropriate wiring diagram. Use approved connectors for attaching all wires. If only
one input for the “Do Not Flush” light is needed, either connect both the red and white wires together or iso-
late one wire with an approved wire nut or equivalent. Make sure to run wires through the backing plate and
allow enough excess for easy connection to the VacuStat panel.
4. Snap the VacuStat panel into the backing plate after all wiring is completed.
5. Snap the Vimar or Gewiss decorative cover (not supplied) over the assembled VacuStat panel and backing
plate.
VacuStat Wiring Identification
Installation Instructions
VacuStat
Status Panel
with Vimar and Gewiss
Control Panels
(does not apply to 3600 series
VacuFlush toilet installations)
Dometic Sanitation Corporation
13128 State Rt. 226, P.O. Box 38
Big Prairie, OH 44611-0038 USA
330-496-3211
1-800-321-9886 • Fax: 330-496-3097
® Registered; ™ Trademark of Dometic Corporation
© Dometic Corporation