SeaLand VacuStat Status Panel - Manual

Part Number Description
313700012 VacuStat - 12 VDC
313700024 VacuStat - 24 VDC
313700112 VacuStat Magnum Opus - 12 VDC
313700124 VacuStat Magnum Opus - 24 VDC
Specifications
Average Current Consumption for 12 or 24 VDC Models:
0.016 Amps
Panel Material:
Brushed Platinum Polyester
Features
• A desirable accessory for VacuFlush ® systems.
• Continuously monitors status of vacuum for proper operation.
• Green light indicates that it is ready to flush.
• Red light indicates that the vacuum pump is running or, if connected to a TankWatch ® 4 level indicator with shut-
down relay, denotes that the holding tank is full.
• Brushed metallic-look panel complements bathroom décor.
Installation Instructions
1. Choose an appropriate location for the VacuStat panel.
2. Using the mounting hole location diagram, drill (2) 1-inch holes as noted.
3. If necessary, drill two 1/16” pilot holes for the two #4 x 3/8” mounting screws provided. The locations for these holes
are also noted on the hole location diagram.
4. Route wiring according to the wiring diagram. Use approved connectors for attaching all wires. If only one input for
the “Do Not Flush” light is needed, either tie both the red and blue wires together or isolate one wire with an approved
wire nut or equivalent.
5. Once the wiring is completed, mount the panel with the two mounting screws.
NOTE: In order for the red LED to function properly for both Low Vacuum and Tank Full status, the negative signal from
the Tank Full float switch must be converted to a positive signal. This can be accomplished by using a TankWatch 4 with
a relay or by using a shut-down relay assembly.
Wiring Diagram
Installation Instructions
VacuStat  Status Panel
Dometic Corporation • Sanitation Systems
13128 State Rt. 226, P.O. Box 38
Big Prairie, OH 44611-0038 USA
330-496-3211
1-800-321-9886 • Fax: 330-496-3097
® Registered; ™ Trademark of Dometic Corporation
© Dometic Corporation