SeaLand DVS02 Vacuum Status Control - Manual (Page 6)

6
3.2 “Full tank” indicator
When connected to a “full tank” sensor (see wiring schematics, pp. 8-9), a steady illuminated red light
can indicate that the holding tank is full. (fig.
3 B, page 2).The VacuFlush toilet should not be
operated until the hoiding tank is emptied and the green light turns on .
3.3 Vacuum system control
During the night or other extended periods of non-use, the toilet system’s vacuum level may slowly
dissipate and cause the vacuum pump to operate. To avoid this, switch the VacuFlush system power to
“off” (fig.
3 C, page 2) .
3.4 Features
Continuous vacuum level monitoring. Indicates when VacuFlush toilet is ready to flush.
Vacuum system protection. Magnetic circuit breaker protects pump from damage .
Power indicator for toilet system. Indicates when toilet system power is off or loss of electrical
power .
12 or 24 V DC operation.
4 Components
(fig. 1 , page 2)
Ref Description
1 DVS02 panel cover
2 Mounting frame
3 #6 fastener
4 Circuit housing
5 Specifications
5.1 Materials
Panel frame and mounting frame: ABS Circuit housing: High-density polyethylene
Panel surface: Polycarbonate resin
5.2 Electrical
Current and wattage per indicator light
12 V DC 24 V DC
Amps 0.012 - 0.016 0.012 - 0.016
Watts 0.15 - 0.22 0.29 - 0.45
Circuit breaker – magnetic, manual reset
SIZE F.L. amps Trip amps
10 amps 10 13 .5
5 amps 5 6 .75
Specifications subject to change without notice .
Intended use Dometic Vacuum Status Control Panel
Note
Be sure circuit breaker size of DVS02
panel matches VacuFlush system power
requirements . Refer to wiring
schematics, pp . 8-9 .