Initialize lens with the t.h.c, When to initialize, Initialize – RED REDLINK™ BRIDGE User Manual

Page 20: Additional t.h.c. operations, Redlink bridge operation guide

REDLINK BRIDGE OPERATION GUIDE

955-0064, REV-B | 20

4. Set up additional focus settings, such as Zone and Size, as needed.

5. You can now use the Focus wheel and Iris slider to adjust the Focus and Iris, respectively.

INITIALIZE LENS WITH THE T.H.C.

WHEN TO INITIALIZE

Normally, the lens initializes when you power on the DSMC or swap the lens. However, sometimes the lens may

not operate properly when first connected to the DSMC.
Manually reinitialize the lens in the following situations:

The lens is not behaving as expected.

The focus or zoom was manually changed.

The focus range was changed using the focus range limiter switch on the lens (only applicable to multi-

focus zone lenses).

NOTE: Failing to perform the initialization sequence after any of the situations listed above may result in unde-

fined behavior.

INITIALIZE

1. Press and hold the Initialize button on the T.H.C. for two (2) seconds.

ADDITIONAL T.H.C. OPERATIONS

For detailed information about performing the following T.H.C. operations, see the

, available at

Set a lens limit

Remove a lens limit

Set a lens lock

Remove a lens lock

Record Start/Stop

Upgrade the T.H.C.