RED REDLINK™ BRIDGE - Manual (Page 19)

REDLINK BRIDGE OPERATION GUIDE
COPYRIGHT © 2014 RED.COM, INC 955-0064, REV-B | 19
PAIR THE T.H.C. WITH THE REDLINK BRIDGE VIA A WIRED CONNECTION
1. Dock the REDLINK Bridge to the DSMC.
2. Connect the AUX port on the T.H.C. to the AUX port on the REDLINK Bridge using the REDLINK-to-T.H.C.
Connector Cable (3').
3. Toggle the power switch to Cable mode.
The T.H.C. automatically pairs to the REDLINK Bridge.
4. Install a RED LI BATTERY 7.2V.
5. Toggle the T.H.C. power switch to Battery mode.
6. Remove the REDLINK-to-T.H.C. Connector Cable (3').
The T.H.C. searches for the wireless connection. The wireless LED stops flashing and remains solid blue
when connected.
7. In the DSMC menu, go to Menu > Settings > Setup > Motor Control.
8. Select the Wireless tab.
9. Select the Enable Wireless Controller check box.
10. Select the channel from the Channel drop-down menu. The default is Channel 1, and you can select one
out of 42 channels.
11. Select the strength of the wireless signal from the Power drop-down menu:
‒ Low: The low power setting balances range and low power and is appropriate in most cases.
‒ High: For maximum range, the high power setting can be used.
NOTE: Be sure to set wireless signal power appropriately. If the wireless signal power is set to High, the T.H.C.
may not perform as desired or may lose connection if operating in close proximity to the REDLINK Bridge.
When using the High setting, the T.H.C. should be at least one (1) meter from the REDLINK Bridge for
proper operation.
SET UP FOCUS AND IRIS CONTROL
After the T.H.C. is paired to the REDLINK Bridge, set up the lens and DSMC Focus settings so that you can
successfully control Focus and Iris.
1. Set the switch on the side of your lens to autofocus. The switch label depends on the type of lens:
‒ Canon: Switch to AF.
‒ Nikon: Switch to M/A.
2. In the DSMC menu, go to Menu > Focus.
3. Select Manual from the Mode drop-down menu.