Philips MC5037 - Manual (Page 25)

Clock/Timer
Timer Setting
The system can switch on to CD,TUNER, or
TAPE mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT!
- Before setting the timer, ensure that the
clock is set correctly.
- The timer will always be switched on
after it has been set.
- The timer will not start if a recording is in
progress.
- The volume of the timer will increase
gradually from the minimum level to the
lost tuned volume level.
1 Press and hold TIMER on the remote control
for more than two seconds.
-> "Hi'1 iS'OO" or'uU^uU" orthe last timer
setting will start flashing.
-» TIMER © will start flashing.
The selected source will be lighted while
other available sources are flashing.
2 Press CD 1'Z*3, TUNER or TAPE to select
the desired source.
9 Before setting the timer make sure the music
source has been prepared.
CD 1*2«3 - Load the disc(s).To start from a
specific track, make a program (refer to "CD
Operation - Programming the disc tracks”).
TUNER - tune to the desired radio station.
TAPE - load a prerecorded tape.
3 Press or ►► repeatedly to set the hour for
the timer to start.
4 Press M or ►! repeatedly to set the minute for
the timer to start.
5
Press TIMER to store the start time.
-♦ "TIMER OM" will be displayed and followed
by the set timer ".X.X’'.X'.X'" and then the selected
source.
TIMER 0 will remain on the display.
9 At the preset time, the selected source will play.
To exit without storing the setting
9 Press ■ on the system.
Notes:
- If CD is the selected source and it is not
available when the preset tim e is reached,Tuner
will be selected automatically.
- During timer setting, if no button is pressed
within 90 seconds, the system wilt exit tim er setting
mode automatically.
To check the TIMER
Press TIMER on the remote control.
If the timer has been activated, the set timer
information will be displayed.
If the timer has been deactivated,
be displayed.
will
To activate/deactivate the TIMER
Press TIMER ON/OFF repeatedly on the
remote control.
-♦ If activated, the last set timer information will
be shown for a few seconds and tjmer © will
appear on the display.
If deactivated, "OFF” will be displayed.
To deactivate the wake up timer (five
minutes interval)
After timer wake up, press SNOOZE on the
remote control.
-> The system will switch to standby mode for
five minutes. After that, it resumes the timer last
selected source again.
To cancel the snooze function, press SNOOZE
again.
Note:
- You are only able to activate the Snooze
function within 30 minutes after tim er wake up.
25