Preparations, Fm antenna, C) speakers connection – Philips MC5037 User Manual
Page 10: Front speakers, Connecting other equipment to your system, Digital out connection, Inserting batteries into the remote control, Optional connections, Subwoofer out connection
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Preparations
FM Antenna
• For better FM stereo reception, connect an
outdoor FM antenna to the FM ANTENNA
terminal.
(c) Speakers Connection
Front Speakers
Connect the speaker wires to the SPEAKERS
(FRONT) terminals, right speaker to ”R" and left
speaker to "L", colored (marked) wire to " +"
and black (unmarked) wire to " —",
C Fully insert the stripped portion of the speaker
wire into the terminal as shown.
Notes:
- For optimal sound performance, use the
supplied speakers.
- Do not connect more than one speaker to any
one pair of -hi — speaker terminals.
- Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
Connecting other equipment to your
system
Connect the audio left and right OUT terminals
of a TVVCR, baser Disc player DVD player or
CD Recorder to the AUX/CDR IN terminals.
Note:
- If you are connecting equipment with a mono
output (a single audio out terminal), connect it to
the AUX/CDR IN left terminal. Alternatively, you
can use a "single to double” cinch cable (still be
mono sound).
Digital Out Connection
Connect this digital output when recording on
any audio equipment with digital input (CD
Recorder Digital Audio Tape [DAT] deck. Digital
to Analog Converter and Digital Signal Processor,
for example). Use a cinch cable to connect the
DIGITAL OUT terminal to the digital input
terminal of the equipment.
Inserting batteries into the
Remote Control
nserttwo batteries (Type R06 orAA) into the
remote control with the correct polarity as
ndicated by the + and — symbols inside the
battery compartment.
Optional Connections
The optional equipment and connecting cords
are not supplied. Refer to the operating
instructions of the connected equipment for
details.
Subwoofer Out Connection
Connect the subwoofer to the SUBWOOFER
OUT terminal. The subwoofer reproduces just
the low bass sound effect (explosions or the
rumble of spaceships, for example).
CAUTION!
- Remove batteries if they are exhausted
or will not be used for a long time,
- Do not use old and new or different
types of batteries in combination.
- Batteries contain chemical substancesi so
they should be disposed off properly.
10