Philips MC5037 - Manual (Page 21)

Tape Operation/Recording
IMPORTANT!
- Before playing a tape, check and tighten
slack tape with a pencil. Slack tape may get
jammed or may burst in the mechanism.
- C-120 tape is extremely thin and is easily
deformed or damaged. It is not
recommended for use in this system.
- Store the tapes at room temperature and
do not put them too close to a magnetic
field (for example, a transformer, TV or
speaker).
Tape Playback
1 Press TAPE to select tape mode.
2 Press OPEN to open the tape deck door.
3 Insert a recorded tape and close the tape door
• Load the tape with the open side down and the
full spool to the left.
№ UZZ3
M..
Press PLAY ►(►II) to start playback.
-♦ ” " with playback direction indicator will
appear on the display.
To stop playback
Press ■.
To change the playback side
Press M or ►!.
-» The (BACK) or ► (FRONT) appear on
the display, depending on the tape side selected.
To change the playback mode
Press AUTO REV. on the remote control
repeatedly to select the different playback
modes.
H : playback on one side of the tape only,
db : both sides are played once.
CTb ; both sides are played repeatedly up
to 10 times each side unless you press ■.
To rewind or fast forward during
playback
Press and hold or ►► until the desired
passage is reached, then release.
The tape continues playing.
The tape will stop automatically at the end of
the tape during rewinding or fast forwarding.
^ During searching, the sound is reduced to a
low volume.
To rewind or fast forward when playback
is stopped
Press AA or ►►.
Press H when you reached the desired passage.
21