Philips MC5037 - Manual (Page 13)

Basic Functions
IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
If Plug and Play has not been installed
When you turn on the system, "fli.l'rO
INSTHLL - PRESS PLAY" will be displayed.
Press PLAY ►(►II) on the system to start
installation,
“INSTFiLL" will be displayed and followed
by “TUriER" and then "flUTO".
^ PROGRAM will start flashing.
The system will search for all radio stations
on the FM band, then the AM band.
-> All available radio stations with sufficient signal
strength will be stored automatically.
“> The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
-» The last preset radio station will play when
Plug and Play is completed.
To reinstall Plug and Play
In Standby or Demonstration mode, press and
hold PLAY ► ( ►!!) on the system until
''fll.n"U INSTnL.,i... ■■ PRESS Pi..HY'"is
displayed.
2 Press PLAY ►(►II) again to start installation.
All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
• Press ■ on the system.
Notes;
- When the power is turned on, the disc tray may
open and dose to initialize the system.
- If you do not complete Plug and Play installation,
Plug and Play will be reinitiated the next time you
turn on the power.
- If no stereo frequency is detected during
Plug and Play, "CHECK flHT’ENNfl" will be
displayed.
- During Plug and Play, if no button is pressed
within 15 seconds, the system wilt exit Plug and
Play mode automatically.
13