Canon B45 - Manual (Page 102)

9-10
The document may not have been loaded correctly into the document tray.
• Remove the document, stack it if necessary, and load it into the document tray correctly
(see p. 3-2).
❏ Cannot send using Error Correction Mode (ECM).
The receiving party’s fax machine may not support ECM.
• If the receiving party’s fax machine does not support ECM, then the document is sent in
normal mode without error checking.
ECM may be disabled.
• Make sure ECM is on (see ECM TX, p. 7-3).
❏ Errors occur frequently while sending.
The telephone lines may be in poor condition, or you may have a bad connection.
• Lower the transmission speed (see TX START SPEED, p. 7-5).
Receiving problems
❏ Cannot receive a document automatically.
The fax may not be set to receive automatically.
• For the fax to receive faxes automatically, the receive mode must be set to FAX ONLY
MODE, FAX/TEL AUTO SW (Fax/Tel mode), or DRPD (see Chapter 5).
The fax may have a document stored in memory.
• Print out any documents stored in memory (see p. 4-14).
An error may have occurred during reception.
• Check the LCD for an error message (see p. 9-15).
• Print an activity report and check for an error (see p. 7-7).
The multi-purpose tray may be empty.
• Make sure paper is loaded in the multi-purpose tray (see p. 1-8).
The telephone line may not be connected properly.
• Make sure all line connections are secure (see p. 1-4).