Oakworks Trolley - Manual (Page 5)

4
dIrectIonS for uSe
directions
for
use
InStallIng optIonal hot towel warmer
1. Set the warmer on the floor in
front of the trolley.
2. Turn off the switch
to the power strip and
plug in the warmer. Turn
on the switch to the power strip.
Open the cabinet doors & remove the adjustable shelf & pins.
Reverse installation instructions on page 4.
3. Set the warmer into the cabinet
making sure the power cord is
routed towards the back.
4. Your towel cabi is ready to use.
Be sure to keep Trolley doors open
when towel cabi is in use.
cautIon
Keep trolley doors open when
towel cabi is in use.
be sure to follow towel warmer
manufacturer’s instructions.
InStallIng optIonal Stone warmer
1. Slide the stone warmer into the
hole in the rear of the trolley. The
controls can face towards the front of
the trolley.
2. Route the power cord out of the
rear access and into the lower cabinet
access hole.
3. From the front, open the cabinet
doors and switch the power strip to
the off position.
4. Plug the stone warmer into the
power strip & switch the power
strip back to the on position.
cautIon
do not operate hot stone
warmer with trolley top
closed. doing so will cause
accelerated damage to the
top surface. top must be
open when hot stone warmer
is in use in order to release
the steam caused by the
stone warmer.
be sure to follow stone warmer
manufacturer’s instructions.
cautIon
make sure the hot towel cabi
door is closed properly and
the drainage tray is emptied
to prevent damage to the
trolley.