Oakworks Spine Positioning System II - Manual (Page 19)

1. Use 1/2” socket wrench to grasp
the locknut.
2. Hold the cam with other hand.
3. Tighten the cam until there is no
gap between the 2 metal parts.
Bad (gap)
Good (no gap)
16
InSPeCTIOnS & MAInTenAnCe / WARRAnTy / SPeCIfICATIOnS
fACe ReST PlATfORM CAM TIghTenIng
WARRAnTy
View complete warranty details at www.oakworks.com
PRODUCT SPeCIfICATIOnS
Component Aluminum equivalence Dimensions
radiolucent Frame 1.20 mm @ 100 kVp, HVL of 3.6 mm 1/4” x 12” x 32.5” (.6 x 30 x 84 cm.)
Crescent Face Pad .72 mm @ 100 kVp, HVL of 3.6 mm 12” (30 cm.) diameter
Contoured Torso support Pad 1.10 mm @ 100 kVp, HVL of 3.6 mm 23” x 30” x 6.5” (58 x 76 x 17 cm.)
Contoured Torso Wedge .70 mm @ 100 kVp, HVL of 3.6 mm 22” x 29” x 2” (56 x 74 x 5 cm.)
small Adjuster Pad .35 mm @ 100 kVp, HVL of 3.6 mm 7” x 12” x 1.5” (18 x 30 x 4 cm.)
Large Adjuster Pad .35 mm @ 100 kVp, HVL of 3.6 mm 8” x 22” x 2” (20 x 56 x 5 cm.)
8” (20 cm.) semi-round Bolster N/A 6” x 8” x 26” (15 x 20 x 66 cm.)
envIROnMenTAl COnDITIOnS
Conditions Temperature humidity Atmospheric Pressure
Normal Use 50° (10°C) to 104° (40°C) 20% to 60% rH 98 to 105 kPa
storage & Transport -20° (-29°C) to 135° (57°C) 20% to 95% rH 98 to 105 kPa