Oakworks Portal Pro 3 Rev.A - Manual (Page 6)

5
1. Release the arm-rest cam lock and the strap to fold the arm rest.
Lock the cam.
2. Fold down the face rest and relock the cam locks and tighten the
knobs (Fig 5).
3. Put the push button on the seat tube into the third hole from the bottom.
4. Lean the chair forward and push in the seat. The chair will fold
(Fig.6). Push on the seat to lock it in the folded position.
5. The massage chair has wheels, so you can pull it along smooth
surfaces by holding onto the face rest. Use the spacer bar on the
face rest as a handle for pulling your chair. Stand behind the seat
and grab the spacer bar. Pull it toward you.
6. Your chair is designed to protect the pads by keeping them far
off the floor as you pull it (Fig.7).The wheels will roll on any surface.
To carry your chair, lift by holding onto one of the main tubes
at the pivot bolt and resting the seat pad against your hip. The
optional shoulder strap will make carrying your chair easier. (Fig.8)
Fig. 12
Fig. 6
Fig. 7
Fig. 8
Fig. 9 Fig. 10
Fig. 5
Fig. 11
Close-up of
wheels
The carry case protects your chair in transport.
1. To put your chair in its case, follow directions above for folding your
chair. Relock all of the cam locks.
2. With the zipper open all the way, drape the case over the top of your
chair as it is standing. The zipper should be on the side of the chair.
(Fig. 9)
3. Zip the zipper closed as far as you can. (Fig. 10)
4. Put the chair on its side and bring the case up over the legs.
5. Zip the zipper closed leaving the wheels exposed for easy rolling
(Fig.11) or tuck them neatly inside for lightweight carrying. (Fig.12)
FOLDING AND CARRYING YOUR CHAIR
TRANSPORTING YOUR CHAIR
DIRECTIONS FOR USE