Oakworks Clinician Adjustable - Manual (Page 5)

WARNINGS
4
ARM REST
INSTRUCTIONS
ARM REST INSTALLATION AND ADJUSTMENT INSTRUCTIONS
OPTIONAL ACCESSORY
AVAILABLE ON SALON TOP ONLY
Manicure Arm Rests Adjustable Side Arm Rests
1. Insert end of arm rest into
hole in back rest while holding
arm rest at 60° angle.
2. Push end all the way into hole and drop arm rest into horizontal
position. Tug slightly to make sure the arm rest is fully locked to
the table (for client safety).
To remove the arm rest, simply reverse the procedure above.
TO INSTALL THE ARM REST:
The arm rests adjust automatically as the table’s back support moves to remain parallel to the floor in any position.
They are designed to be strong and will take a reasonable amount of weight, but they are not designed to be used to
sustain a person’s weight when getting on or off the table.
CAUTION: Do not use the arm rest for
client weight support during the mounting
or dismounting of the table. The arm rest is
not designed to support the client’s weight.
The arm rest height is adjusted to level at the factory. When in use, some of the new
parts will wear, and you may see some sagging of the arm rest over time. If the arm
rest is too low the height can easily be adjusted using the enclosed Allen wrench.
1. Loosen bottom 2 set screws
(turn counter-clockwise).
2. Turn side set screw in (clock-
wise) while lightly raising the arm
rest with your other hand (to make
the adjustment easier).
3. When you have achieved the desired
height, tighten the two bottom set screws
(turn clockwise).
1. Loosen bottom 2 set screws
(turn counter-clockwise).
2. Turn side set screw out (turn
counter-clockwise).
3. When you have achieved the desired
height, tighten the two bottom set screws
(turn clockwise).
To Raise the Arm Rest
To Lower the Arm Rest
TO LEVEL THE ARM REST: