Oakworks Clinician Adjustable - Manual (Page 2)

ASSEMBLY
INSTRUCTIONS
WARNINGS
TABLE ASSEMBLY INSTRUCTIONS
1
STEP 1
Place the table top upside down on the floor.
Parts Included:
1 - Wrench 8 - Washers 8 - Nylock
Nuts
1 - Table Top
1 - Shelf 4 - Main Legs
w/extensions
STEP 2
Each leg has a number by the top bolt that corresponds
with a number on the inside corners of the table top.
(Excluding non-cabinet versions of the Flat top and
Back Rest top tables. These legs are universal.) Pick
any leg and match the number. Place the top leg bolt
through the metal corner bracket (note – if you have an
adjustable leg section, it may be necessary to raise the
leg section to install the leg). Attach washer and nut
and tighten this bolt using the supplied wrench or your
own ½” socket wrench. Install one leg only.
STEP 3
Place the shelf upside down on top of the table top.
Lift the corner of the shelf and place the bottom leg
bolt through the metal corner bracket of the shelf.
Place a flat washer and nut on the bolt and hand
tighten only.
STEP 4
Find the leg for the opposite corner
(match the number). Lift the shelf
and insert the 2 leg bolts through
the 2 metal corner brackets. Place
a flat washer and nut on each bolt
and turn the nut into position with
the wrench, but do not completely
tighten.