beautypg.com

Caution, Directions for use, Paper roll holder use – Oakworks 300 Series Procedure Chair Rev.C User Manual

Page 13: Arm rest installation and adjustment

background image

10

DIReCTIOnS fOR USe

To load the paper, locate the two

paper holder support arms located

on the underside of back rest.

Insert rod through paper roll and place

rod into the holes in the support arms.

PAPeR ROll HOlDeR USe

Pull paper and thread through the

straps across the upholstered top to

keep in place.

ARM ReST InSTAllATIOn AnD ADjUSTMenT

CAUTIOn

Do not use the arm rest for patient support during the mounting or dismounting of the chair.

The arm rest is not designed to support the patient’s weight.

TO InSTAll THe ARM ReSTS:

The Arm Rests adjust automatically as the back rest moves to remain parallel to the floor.

1. Insert end of arm rest into back-

rest hole while holding the arm

rest at a 60° angle to the backrest.

2. Push end all the way into the hole and drop the arm rest into the horizontal

position. Pull outward to make sure the arm rest is secure.

To remove the arm rest, simply reverse the procedure above. If the Arm Rest(s) are not level – Refer to the

Service Manual.

Note: The paper “hold down” strap is attached with Velcro

®

. This allows strap tension adjustment if necessary.