Oakworks 121A Procedure Chair Rev.D - Manual (Page 9)

6
DIRECTIONS FOR USE
ARM REST USE
TO LOWER THE ARM RESTS
Push arm rest in lightly towards the center of the table,
then pull locking knob down towards the table base.
Fold arm rests down and under the table.
TO RAISE THE ARM RESTS
Grasp arm rest and rotate to the raised position. When
fully up, the arm rest will lock into position. Check that the
arm rest is locked by applying light outward pressure.
1. Fully lower the manual
adjustable foot rest to allow
access to the stirrup.
3. Fold out to fully open posi-
tion.
2. Grasp Stirrup handle &
pull out firmly while lifting
slightly. Pull fully out.
4. To rotate stirrup
to the desired angle, lift
slightly and move to the
desired position. There are
3 detent positions. Stop
lifting and move slightly
left or right for the nearest
detent position.
5. To reduce stir-
rup length, lift the handle
slightly and push into
desired position. Stirrup
will automatically lock into
nearest detent position.
To store stirrups, lift slightly, rotate towards the middle of the table and fold
the foot rest down. Then lift slightly and push into the storage position.
RETRACTABLE FOOT RESTS (STIRRUP) USE
CAUTION
Pinch Point - Keep fingers away from pinch point.
PAPER ROLL HOLDER
To load the paper, locate the two
paper holder support arms located
Insert rod through paper roll and
place rod into the holes in the
Pull paper and thread through the
straps across the upholstered top to
keep in place.
Note: The paper “hold down” strap is attached with Velcro ® . This allows strap tension adjustment if necessary.