NORAC UC4.5-BC Operator Manual User Manual
Page 33
29
8.4 Quick Install
The Quick Install feature of the UC4.5 Spray Height Control System is designed to help
diagnose problems that cannot be identified during the Automatic Setup. It will instantly setup
the system with typical values for hydraulic calibration and sprayer geometry, based on the
sprayer type selected. Perform the following procedure for a Quick Install.
STANDARD SYSTEM (Including Passive Roll):
•
The system must have a minimum of two sensors.
•
Verify the sensors are installed with the lowest serial number on the left side increasing to
the highest serial number on the right side.
•
Level the boom at 35 inches (90 cm) height.
•
Navigate in the setup menu to the "Install?" screen and press the
button.
•
Use the
buttons to toggle through a list of available sprayer types. The types are
listed in Section 14.
•
Press and hold
for 5 seconds.
•
When the word "Sensor" is displayed, release the button. The system will be configured
with the standard settings based on the type selected and the number of sensors present.
•
The UC4.5 system will now prompt the operator to perform a push test (Section 8.1.6 -
Boom Geometry Tuning).
•
Perform a ReTune (Section 8.2).
Sensor
Type +/-
Select
AN2 ?
Install ?