NORAC UC4.5-BC Operator Manual - Manual (Page 19)

15
the oil. For pull-type sprayers, ensure any hydraulic flow controls are adjusted for normal field
operation. Changing the hydraulic flow controls after or during the system setup will affect the
UC4.5 performance.
8.1.2 Turn On the UC4.5 Control Panel
• If this is the first setup for the panel, the process will begin automatically. If the panel was
previously set up, select "Install?" from the setup menu to initiate the Automatic System
Setup.
8.1.3 Select the Sprayer Type
• Use the buttons to toggle through a list of available sprayer types. The types are
listed in Section 14.
• When the desired type is shown, confirm the selection with the button.
• To exit the install now before changing any settings press the button.
• The control panel is loading all the settings for the sprayer.
8.1.4 Wiring Test
• Use the sprayer's manual controls to move the left boom up.
• If the wrong boom moves or if the direction is incorrect, stop the setup. Consult the
UC4.5 Installation Manual to check the hydraulic plumbing and electrical wiring of the
system.
• The control panel confirms the wiring is correct. Continue the process with the
remaining booms, as shown.
AN2 ?
Type +/-
Left Up
Select
Dfalting
Press
Left
Ok