NORAC UC4.5-BC Operator Manual User Manual
Page 23
19
8.2 Retune
From time to time it may be necessary to recalibrate (Retune) the UC4.5 electronics to the
sprayer’s hydraulics. Examples of such times are:
•
A hydraulic solenoid valve has been changed.
•
The hydraulic pump has been changed or adjusted.
•
A different tractor has been connected to the sprayer.
•
The tractor’s hydraulic flow control has been adjusted.
If running a pull type sprayer and using different tractors to operate the sprayer, run the Retune
procedure each time the tractor is changed. If there is a flow control for the boom hydraulics,
set it prior to tuning. If the flow setting is changed by more than 20 percent, run a Retune.
Follow Section 8.1.1 (level booms, working RPM, etc.) before beginning the Retune. Navigate
to the "Retune?" menu prompt in the SETUP (
) menu and confirm with the
button. The
procedure described in the Automatic System Setup, starting at Section 8.1.7 will begin.
Note: The booms are to be leveled at a normal working height when Retune starts – it is not necessary
to set them to 35 inches. The 35 inch height is only required during the Automatic System Setup.