NORAC UC4.5-BC Operator Manual - Manual (Page 24)

20
8.3 Manual Setup
The UC4.5 Spray Height Control System will not operate in automatic mode until the system
has been configured. It is recommended that the Automatic System Setup be used, but if
necessary, a manual system setup may be used. The manual system setup involves setting up
each sensor (programming serial numbers and sensor locations) as well as tuning the hydraulic
parameters manually.
8.3.1 Sensor Setup
Before beginning, it is necessary to know the serial number and
location for each of the sensors. The sensor serial number is located
on the bottom of the sensor housing, beside the foam disc.
It is recommended that the sensor location and serial number be
recorded in Figure 7 because this information may be required during
troubleshooting.
Figure 7: Sensor Serial Numbers and Positions