NORAC UC4+BC+JD8A - Manual (Page 28)

24
4.7.4 Hydraulic Plumbing
WARNING!
From this point in the installation the
booms will be inoperative until the
electronics are fully installed.
1. After the NORAC valves are mounted,
the hydraulic hoses and fittings can be
plumbed. The plumbing for the hydraulic
circuit is shown schematically in Figure
3.
2. Tee hose H71 into the sprayer’s main
hydraulic supply located on the left hand
side, under the rear corner of the cab
outside the frame. Be sure to connect
the tee fitting into the “EF” port of the
priority valve. Use the 12FORXR-
12MORT Tee fitting (F11) (Figure 30).
Figure 30: Secondary Pressure Line Connection