NORAC UC4+BC+JD8A - Manual (Page 20)

16
4.6 T
ARGET
I
NSTALLATION AND
A
LIGNMENT
NOTE: It is very important that the
rods be installed on the right hand
side of the sprayer.
The sprayer must be level when
installing the UC4+ Roll Control
System. The sprayer booms
should be level as well, parallel to
the sprayer’s lift frame.
1. To ease the installation of the UC4+
Roll Control system, unfold the sprayer
on a level area and lower the center
section to three or four feet above the
ground. A ladder or step will also be
required to complete the installation.
Figure 15: Roll Control Items
Figure 16: Typical Roll Control Install
Bumper
Frame
Target
Roll
Control
Frame
Sprayer Parallel Lift
Frame
Sensor
Bracket
Roll
Sensor
Spring
Target
Boom Centre
Frame
Remove the Rubber
Bumper
Sensor Bracket (B14)
Spring Target (B12)
Frame Target (B09)