New England Arbors VA42055 - Manual (Page 11)

www.edenarbors.com
11
12 x 12 Flat Top Pergola
1
Vinyl Rafter Assembly
Insert one 2x6x12 pressure treated wood into a rafter section
followed by the joiner and another rafter section.
Temporarily insert the pergola ends into both end of the rafter as
shown aside. Due to the lengh variation in wood, this will ensure
that the pergola ends will go on perfectly.
Please Note:
If there is a gap between the pergola end and rafter, remove 2x6
wood and trim down wood beam appropriately.
Screw the joiner to vinyl rafters and wood insert using 1 1/2”
screws.
Remove and set aside pergola ends for the time being.
Repeat steps 1 to 3 for the remainder of the rafters.
1
2
3
STEP FIVE
4
2
Four holes
facing up
4
3
No Gap Gap
 