New England Arbors VA84240 - Manual (Page 3)

STEP T WO
3
The Nantucket Deluxe Arbor
STEP T WO
Insert the horizontal spindles into the middle verticle spindle
(holes on both sides).
Slide the two outer vertical spindles into position as illustrated.
Layout the bottom horizontal rail and insert the vertical
spindles.
Slide top horizontal rail into position.
Repeat for other panel.
Assemble the Side Panels
1
2
3
4
5
1 2
3 4
STEP THREE
Attach Sur-Fit Brackets
Attach Sur-Fit Brackets (using small screws) onto posts using the
pre-drilled holes as guides. Single hole on the side of brackets
to face down.
Set out one post and slide the assembled side panel into.
Fasten horizontal rails into Sur-Fit Brackets using small screws.
Layout the opposite post and insert the finished side panel
with post connected.
Fasten horizontal rails into Sur-Fit Brackets using small screws.
Repeat for other side panel.
1
2
3
4
5
6
1
2
3
5 4
www.newenglandarbors.com
NOTE: Prior to installing Sur-Fit Brackets, insert a wood 4x4 post
approximately 5 ft. (152.4 cm.) up the inside of vinyl cavity
[purchase 4x4x8 to accomodate 3 ft. (91.45 cm.) in the ground]
if you intend to hang a gate, attach a fence or are located in a
high wind area.