New England Arbors VA84242 - Manual (Page 3)

STEP T WO
3
The Fairfeild Deluxe Arbor
STEP THREE
Attach Sur-Fit Brackets (using small screws) onto the posts
using the pre-drilled holes as guides. Single hole on the side
of brackets to face down.
Set out one post and complete the side panel by inserting
the curved toprail first into the hole on the post, followed by
the other two rails into the brackets on the post as illustrated.
Fasten horizontal rails into the Sur-Fit Brackets using small
screws as illustrated. You will need a helper at this stage.
Layout the opposite post and insert the finished side panel
with post connected as illustrated.
Fasten horizontal rail into Sur-Fit Brackets using small screws.
Repeat for other side panel.
Attach Sur-Fit Brackets
1
2
3
4
5
1
2
3
4
5
NOTE: Prior to installing Sur-Fit Brackets, insert a wood 4x4 post
approximately 5 ft. (152.4 cm.) up the inside of vinyl cavity
[purchase 4x4x8 to accomodate 3 ft. (91.45 cm.) in the ground]
if you intend to hang a gate, attach a fence or are located in a
high wind area.
6