Muse Research Receptor v1.7 Release Notes - Manual (Page 28)

Receptor v1.5 Release Notes 28 Muse Research, Inc.
Modified Feature: Route MIDI CCs to Source Plugin
In previous versions, when you enabled this option, Receptor would automatically take all 128 incoming
MIDI˛CC messages and route them to the plugin assigned to the Source slot. This has been changed as follows:
• If the Program Changes parameter is set to Use Bank Select, then Bank Select messages (CC˛00 and
CC˛32) are not routed to the Source plugin and, instead, are used by Receptor as Bank Select messages.
This means you can enable the Route MIDI CCs to Source Plugin feature and Receptor will still respond
to Bank Select messages.
• If the Program Changes parameter is set to Ignore Banks Select and Target , then Bank Select
messages (CC˛00 and CC˛32) are routed to the Source plugin because Receptor no longer needs to reserve
these messages for Bank Select purposes.
NOTE: If you enable the Route MIDI CCs to Source Plugin option and, if a channel uses an audio input for a
source (rather than a VSTi), then Receptor routes the MIDI CCs to the first instantiated FX (A, B, or C).
Removed Feature: System Temperature Monitor
Under critical listening conditions, the System Temperature monitor (which was added to Receptor in v1.4)
could cause minor clicks in the audio signal. As the temperature monitor was basically an informational tool for
Muse Research engineering, it has been removed from version 1.5.