Muchmore Cell Master Platinum (PT-CTXC) - Manual (Page 23)

9.CTX CHARGE SET-UP
KEY OPERATION
E 8
Backward
Set Value
DATA check
Cursor moves, Charge start, stop
CTX charge is 3step charge mode which can set up
different current and capacity for 1/3,2/3,3/3 steps.
The CM doesn’t read voltage (peak detection
locked) during 1/3 and 2/3 step. From 3/3 step, the
CM reads voltage(peak detection on) then terminate
charging.
Use CTX-charge only for batteries that have been
fully discharged.(Zero-V discharger Part#MR-ZV)
We recommend CTX charge for advanced drivers who
have much experience about charging.
e.g. of 1/3step
1/3
7Amp charge
up to 2000mA
2/3
6Amp charge
up to 2700mA
3/3
4Amp
charge
4A
Repeak
0.1A
Trickle
charge
for 5min.
0.1A
Trickle charge
e.g. of 2/3step
e.g. of 3/3step
.CTX CHG 1
.CTX CHG 2
.CTX CHG 1
.CTX CHG 2
2/3 2700mA 6.0A
Fn
3/3 3800mA 4.0A
Ty 50 03 R1
e.g. repeak selected
Delay time
Page 9
Capacity limit
Trickle charge
(Page5)
Cut off temp.
(Page5)
Repeak charge: Rn(don’t repeak) to 3times can be set.
If you select n, the CM will not ask“Set Repeak Time”.
If repeak selected, the CM will repeak in set time with
3/3 setup after CTX-charge termination.
R1:Repeak once, R2: Repeak twice, R3:three times
Repeak Dly
05:00 0000 0200
Repeak Cap
05:00
Volt
Capacity
0 3800 2000 2700
Peak lock Peak lock Peak on
Flex charge(no~9)
Flex charging can recondition cells by lowering the
internal resistance through improvements plate
crystal structure formed by aging cells, they take
better charge and prevents undesirable memory
build-up. It is intended for use with NiCd cells only.
Intensity 1 is lowest and 9 is highest.
1/3 2000mA 7.0A
Fn n 6cell
Cell number
Fan start
temp(Page5)
* * * *