Muchmore Cell Master Platinum (PT-CTXC) - Manual (Page 16)

WARNING
1.CELL MASTER
To reduce the risk of injury, use only rechargeable Ni-CD or Ni-MH or Litheum/Lithium-Ion,
Litheum/Lithium Polimer batteries with the CM. Do not leave the CM unattended. The remote possibility
of a failure could cause an extreme overcharge. This could cause the battery to rupture.
Always make sure all the batteries in the pack are in the same state of discharge before charging a
pack. Otherwise, any cells that are partially charged before charging will get extremely hot and may be
damaged or vent battery acids. To prevent this, make sure the thermo sensor from the CM is always
attached to the battery’s surface. Check your battery pack occasionally for overheating, If cell are too
hot to touch there is something wrong and the pack must be disconnected from the charger.
Muchmore Racing(or their associated distributors) shall not be liable for any property damage or
personal injury which may result from the failure to these instruction or other improper use of this
product.
Avoid any contact of your CM with water or other liquids. Never operate on carpets, cloths, pit towel or
other materials.
Never cover the cooling fans or holes on the CM. Disconnect the CM from power supply when not in
use. Only charge serially switched battery packs containing 1~8cells. Never charge parallel switched
cells. Never connect the CM directly to a 110/230 VAC power source. For best performance, we
recommend the Power Master(24A power supply #MM-CTXP3)
New charger may produce a slight odour in the first few hours of service due to matereials curing
inside the device.
The CELL MASTER Version 1.0(referred to as CM)is a state of the art microprocessor
based charger/discharger system for rechargeable batteries for R/C use. With CTX
technology developed by our team of R&D, factory team drivers and world champion
Surikarn Chaidajsuriya, Muchmore introduces the next generation of charger for serious
R/C drivers.
The CM is linear type and can fully charge 1 to 8 cells at a digitally presettable
amperage up to a maximum 10.0amps using peak detection, temperature limit, capacity
limit methods. The CM can automatically repeak by CTX charge mode.
The CM can charge Litheum battery up to 3 cells.
E 1
Black back lit LCD with 16x2 characters IC controlled ball bearing fans
Gold plated clips High resolution16bit AD for accurate volt reading
6 charging memories Auto restart system Autostart timer
Blue state Indicator Customizable charging name Zero-delta peak cutoff
Ouput control pins for Battery warmer or Cooling fan stand
Dimensions...............................................................
Weight...........................................................................................
No. of cells......................................................................................
Max charge current............................................
Discharge current..............................................
Cut-off Voltage.....................................................
Input Voltage.......................................................................
Charging Capability.......................................
Charging Modes...................
Trickle Charge Rate(after charge).................................................
Voltage Threshold/Delta Peak.......................................
Flex Charge.........................................................
Thermometer sensor.......................................
Keys....................................................................................................
Cooling......................................
124 x114 x 47mm
482g
1~8
0.1~10.0A(adjustable)
0.1~10.0A(adjustable)
0.1~9.9V(adjustable)
10.0~16.0V
10~9990mAh(adjustable)
Peak & CTX charge, Trickle, Flex, Li-Ion
0.1A
Zero, 3~99mV
0~9Level(adjustable)
15~70degrees Celcious
4
Ball bearing temp controlled dual fans
SPECIFICATIONs