MOOER VEM Box - Manual (Page 7)

06
Module Selector: Switches between every function module. In
patch edit mode, this knob selects the module/parameter for operation.
VALUE Knob with Enter Button: Dial the knob for setting master
level, or changing parameter values. Press the button to switch effect
type, ensure storing, etc.
LED Display: Shows bank and patch numbers, setting values, and
other information for operating.
PATCH [REC/OVERDUB] Footswitch: Selects patches
(backwards), start loop recording/overdubbing, and
other functions.
PATCH + [MODULE BYPASS] Footswitch: Selects patches
(forwards), play/stop loop, bypass effect module, and other functions.
Expression Pedal: Adjusts volume or some effect parameters.
EXP. PEDAL LED: Indicates the status of the expression pedal.
MIC IN Jack: XLR + 1/4” TRS audio jack, for connecting
microphone. When operating VEM Box on batteries, plugging Mic
cable into this jack will turn on the unit.
INST. IN Jack: 1/4” mono audio jack, for connecting guitar or other
instruments.
OUTPUT [PHONES] Jack: 1/4” stereo audio jack, for connecting
headphone or amplifier. Using a mono cable can output the signal to
an amplifier, or use a Y cable to output the signal to two amplifiers.
INST. THRU Jack: 1/4” mono audio jack, output the signal directly
10
09
08
07
06
05
04
03
02
01
11
Panel Instruction
11
Also can plug a stereo headphone into this jack.
DC 9V Jack: For power supply, use a 9-volt DC regulated by AC
12
Battery Holder: For installing batteries (AA/LR6 x 4). 13
adapter, 300mA (plug polarity is positive on the barrel and negative
from INST.IN jack.
in the center).