MOOER Micro ABY - Manual

PLEASE READ CAREFULLY BEFORE PROCEEDING
Power Supply
Connections
Always turn off the power of this and all other equipment before connecting or
disconnecting, this will help prevent malfunction and / or damage to other devices.
Also make sure to disconnect all connection cables and the power cord before
moving this unit.
Cleaning
Clean only with a soft, dry cloth. If necessary, slightly moisten the cloth.
Do not use abrasive cleanser, cleaning alcohol, paint thinners, wax, solvents,
cleaning fluids, or chemical-impregnated wiping cloths.
Interference with other electrical devices
Radios and televisions placed nearby may experience reception interference.
Operate this unit at a suitable distance from radios and televisions.
Location
To avoid deformation, discoloration, or other serious damage, do not expose
this unit to the following conditions:
Direct sunlight Heat sources
Magnetic fields Extreme temperature or humidity
Excessive dusty or dirty location High humidity or moisture
Strong vibrations or shocks
Please connect the designated AC adapter to an AC outlet of the correct voltage.
Please be sure to use only an AC adapter which supplies 9V (±10%) DC, center
minus. The maximum working voltage shall not exceed 12V, otherwise may be
dangerous equipment damage, fire or other problems.
Unplug the AC power adapter when not using or during electrical storms.
Precautions
FCC certification
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference
that may cause undesired operation.
 Micro ABY can be used in two ways, the signal path can flow from
A/B to Y, or from Y to A/B
 Can work without power supply (LED will not be lit up)
 Full metal shell
Main Features
1. Channel Select Footswitch:
Push down the footswitch to
switch between channel A and
channel B.
2. A/B LED:
Instructs channel A or channel
B of Micro ABY, channel A
corresponding to the red LED
and channel B corresponding to
the green LED, LED won’t be lit
up without power supply.
3. DC IN Power Jack:
For power supply, use a 9-volt
DC regulated AC adapter (plug
polarity is positive on the barrel
and negative in the center).
4. A Jack:
1/4” mono audio jack, for
connecting instruments.
5. B Jack:
1/4” mono audio jack, for
connecting instruments.
6. Y Jack: 1/4” mono audio jack, for connecting instruments.
Channel A: Red
Channel B: Green
Y
A
B
6
5
4
3
A/B/Y Jack: 1/4” monaural jack
Power Requirements: AC adapter 9V DC (center minus plug), can
work without power (LED doesn’t work). Recommended to use Mooer
Micro Power
Dimensions: 93.5mm (D) × 42mm (W) × 52mm (H)
Weight: 160g
Accessories: Owner’s Manual
* Disclaimer: Any specification’s update won't be amended in this manual.
Basic Using
Micro ABY can be used in two ways, Here are two application examples:
Example Y→A/B
Y(Instrument)→Effects chain A/Effects chain B
Example A/B→Y
Effects chain A/Effects chain B→Y(Amplifier)
Channel Switch Pedal
 Very small and compact design
 True bypass switch
 DC 9V adapter power supply