MOOER MICRO DI User Manual
Precautions, Main features
Input: 1/4” monaural jack (impedance: 1M Ohms)
Output: 1/4” monaural jack (impedance: 1k Ohms)
Power Requirements: AC adapter 9V DC (center minus plug),
recommended to use Mooer Micro Power
Current Draw: 12 mA
Dimensions: 93.5mm (D) × 42mm (W) × 52mm (H)
Weight: 140g
Accessories: Owner’s Manual
*
Disclaimer: Any specification’s update won't be amended in this manual.
Direct Input Box
PLEASE READ CAREFULLY BEFORE PROCEEDING
Power Supply
Connections
Always turn off the power of this and all other equipment before connecting or
disconnecting, this will help prevent malfunction and / or damage to other devices.
Also make sure to disconnect all connection cables and the power cord before
moving this unit.
Cleaning
Clean only with a soft, dry cloth. If necessary, slightly moisten the cloth.
Do not use abrasive cleanser, cleaning alcohol, paint thinners, wax, solvents,
cleaning fluids, or chemical-impregnated wiping cloths.
Interference with other electrical devices
Radios and televisions placed nearby may experience reception interference.
Operate this unit at a suitable distance from radios and televisions.
Location
To avoid deformation, discoloration, or other serious damage, do not expose
this unit to the following conditions:
Direct sunlight
Heat sources
Magnetic fields
Extreme temperature or humidity
Excessive dusty or dirty location
High humidity or moisture
Strong vibrations or shocks
Please connect the designated AC adapter to an AC outlet of the correct voltage.
Please be sure to use only an AC adapter which supplies 9V (±10%) DC, center
minus. The maximum working voltage shall not exceed 12V, otherwise may be
dangerous equipment damage, fire or other problems.
Unplug the AC power adapter when not using or during electrical storms.
Precautions
FCC certification
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference
that may cause undesired operation.
6. GAIN Switch: Switches the gain value between -20dB, 0dB and +20dB.
7. CABINET SIMULATOR Switch: The virtual 4x12” cabinet simulation
can be switched on and off by the OFF/ON switch.
8. GND LIFT Switch: When pushed down, it breaks the ground connection
between input and output. This can eliminate hum or ground loops
depending on the grounding of the connected equipment.
Full metal shell
Very small and compact design
DC 9V adapter power supply
Main Features
Smart direct input box with ultra low distortion, it quietly transfers
the sound of guitar or bass directly to the audio system
Balanced/unbalanced output, gain switch, cabinet simulator and
ground lift function included
1. Status LED
Instructs the working status of
Micro Di, when lit up, the unit is
at work, GREEN light indicates
CABINET SIMULATOR is off,
RED light indicates the CABINET
SIMULATOR is on.
2. DC IN Power Jack:
For power supply, use a 9-volt
3. INPUT Jack:
mono audio jack, for
connecting guitar or bass.
4. BALANCED OUTPUT Jack:
XLR BALANCED output jack,
outputs the signal.
5. UNBALANCED OUTPUT Jack:
1/4” mono audio jack, outputs
the signal.
:
1/4”
DC regulated AC adapter (plug
polarity is positive on the barrel
and negative in the center).