Millennia HV-3R Eight Channel Remote-Control Microphone Preamp v 1.4.2 - Manual (Page 15)

page 15 of 40 rev 1.4.2 041409 Millennia Media HV-3R
Installing the Ælogic Software – Insert the
Ælogic Disc into the computer (Windows XP or Vista
only) that will be used to control the HV-3R(s). The
following screen will appear. If it doesn’t, browse to
the CD and open setup.exe
Select the desired options and click on “Install”.
The following screen will appear if the install is
successful:
Be sure the computer is set to IP address
192.168.1.200
Setting the Host Computer’s IP Address (XP)
1. Go to Network, right click on the Local Area
Connection and open Properties.
2. Double click on Internet Protocol (TCP/IP) to
open its properties.
3. Select “Use the following IP addresses.
4. Enter 192.168.1.200 in IP Address.
5. Enter 255.255.255.0 in Subnet mask.
6. Click OK and continue to exit out of Network
Connections.
7. Connect the Host Computer and HV-3R(s) LAN
Ports to the same router/switch.
8. Run the Ælogic Software.