MF Digital USB SD 5000 Platform Series - Manual (Page 13)

13
© www.mfdigital.com USB SD Platform 5000 series
If the Source capacity is Greater than the target, for example 2GB to 1GB:
When the source content is within the target flash card’s capacity
A. Source B. Target
2GB 1GB
(Data)
When the source content exceeds the target flash card’s capacity
A. Source B. Target
2GB 1GB
FAT16/32 Data
3.6 Asynchronous Copy Mode
The function can be enabled by selecting “ON” or disabled by selecting “OFF". If
asynchronous copy is enabled and the source content size is less than the system’s
buffer memory it will automatically start the asynchronous copy process. If the
asynchronous copy is disabled no matter what the content size or which copy
method has been selected the system will only use the synchronous copy mode.
3.7 Language
This function enables the user to choose the language of the system interface.
3.8
Working mode
This function enables the user to choose between the “Turbo mode” and “Normal
mode”. Turbo mode can support high speed Flash with a high speed copy. If using
the “Turbo mode” function please ensure sure the Flash cards support high speed
transfer and are of a good quality. If the Flash card is bad quality there will be errors
in the transfer of data, when using Turbo mode. The factory default System setting is
“Normal Mode”.
O -- Copy OK . The copying process will
succeed as the capacity of the target device is the
same size as the amount of data to be
transferred.
X
X -- Copy Fail .
The copying process will
fail as the capacity of the target device is smaller
than the amount of data to be transferred.