Maxim Integrated MAX11300PMB1 Peripheral Module and Munich (USB2PMB1) Adapter Board - Manual (Page 5)

MAX11300PMB1 Peripheral Module and Munich (USB2PMB1) Adapter Board Quick Start Guide
The Munich adapter board is designed to supply power to external boards (i.e.,
MAX11300PMB1, Santa Fe, and many more) through the connector X2. It is intended to
provide power supply to the interface circuitry present in the connected board.
Figure 3 shows the pin configuration for the SPI-compatible connector at the
USB2PMB1 board. The MAX11300PMB1 board itself generates positive voltages from
3.3V on pins 6 and 12 with an on-board DC-DC converter. The 3.3V supply is limited to
~1.5W, limiting power available for the MAX11300PMB1 if a higher watt power supply is
required and external power supply is used. Refer to the MAX11300PMB1 data sheet
for details.
7
10
8
9
11
12
1
4
2
3
5
6
X1
SPI
CS
MOSI
MISO
SCLK
GND
3.3V
3.3V
GND
X
INTB
CNVTB
Figure 3. SPI Connector Inputs Found on the MAX11300PMB1
5