Leapers 2.6 ITA Red/Green CQB Micro Dot with Integral QD Mount (SCP-DS3026W) - Manual (Page 16)

14
E. Zero the Dot Sight:
Note: Leapers dot sight comes with three different
adjustment turrets as shown below:
The purpose of zeroing the dot sight is to ensure that the
illuminated dot is aligned with the impact point of your rifle. Before
zeroing, read the following adjustment knob instruction carefully.
1. Unscrew and remove the cap of the adjustment knob.
2. Unlock the Windage/Elevation Turrets (for the version
without the lockable function, please skip or ignore
the related ‘lock’ and ‘unlock’ steps or descriptions)
I. Both windage and elevatoin knobs were set to the
Locked Position at the factory. Gently dial the knob
and test if it is locked. If not, you can skip section II.
II. Locate the locking screw(s) on the turret. Use the
included small Allen wrench to unlock the screw(s)
by turning them counterclockwise ¼ revolution.
Double Lock Turret Zero Deadlock
Turret
No Additional
Lock Turret
(2 locking screws) ( 1 locking screws)